Machine Design In the levers of __________ type, the mechanical advantage is less than one. Third None of these Second First Third None of these Second First ANSWER DOWNLOAD EXAMIANS APP
Machine Design The connecting rod bolts are tightened up with initial tension greater than the external load so that Bolts will not loosen during service Bolts are weakest elements The resultant load on the bolt would not be affected by the external cyclic load Joint may not open up Bolts will not loosen during service Bolts are weakest elements The resultant load on the bolt would not be affected by the external cyclic load Joint may not open up ANSWER DOWNLOAD EXAMIANS APP
Machine Design In replacing the V-belts, a complete set of new belts is used instead of replacing a single damaged belt because New and old belts will cause vibrations Only one belt cannot be fitted with other used belts The new belt will carry more than its share and result in short life Belts are available in sets New and old belts will cause vibrations Only one belt cannot be fitted with other used belts The new belt will carry more than its share and result in short life Belts are available in sets ANSWER DOWNLOAD EXAMIANS APP
Machine Design Failure of a material is called fatigue when it fails At the elastic limit Below the elastic limit At the yield point Below the yield point At the elastic limit Below the elastic limit At the yield point Below the yield point ANSWER DOWNLOAD EXAMIANS APP
Machine Design The design calculations for members subject to fluctuating loads with the same factor of safety, yield the most conservative estimates when using Soderberg relation Goodman relation None of these Gerber relation Soderberg relation Goodman relation None of these Gerber relation ANSWER DOWNLOAD EXAMIANS APP
Machine Design If a load W is applied instantaneously on a bar; Then the stress induced in bar will Depend on other considerations Decrease with decrease in y Increase with increase in y Be independent of ratio of mass of load W to mass of bar (y) Depend on other considerations Decrease with decrease in y Increase with increase in y Be independent of ratio of mass of load W to mass of bar (y) ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS