Machine Design A V-belt designated as B 4430 LP has 4430 mm as diameter of small pulley 4430 mm as diameter of large pulley 4430 mm as centre distance between pulleys 4430 mm as nominal pitch length 4430 mm as diameter of small pulley 4430 mm as diameter of large pulley 4430 mm as centre distance between pulleys 4430 mm as nominal pitch length ANSWER DOWNLOAD EXAMIANS APP
Machine Design A stud Has pointed threads Has head at one end and other end fits into a tapped hole in the other part to be joined Has both the ends threaded Has a head on one end and a nut fitted to the other Has pointed threads Has head at one end and other end fits into a tapped hole in the other part to be joined Has both the ends threaded Has a head on one end and a nut fitted to the other ANSWER DOWNLOAD EXAMIANS APP
Machine Design If T is the actual number of teeth on a helical gear and φ is the helix angle for the teeth, then formative number of teeth is written as T sec²φ T cosecφ T sec³φ T/sec³φ T sec²φ T cosecφ T sec³φ T/sec³φ ANSWER DOWNLOAD EXAMIANS APP
Machine Design Rivets are generally specified by Length of rivet Nominal diameter Diameter of head Thickness of plates to be riveted Length of rivet Nominal diameter Diameter of head Thickness of plates to be riveted ANSWER DOWNLOAD EXAMIANS APP
Machine Design If P1 and P2 are the tight and slack side tensions in the belt, then the initial tension Pi (neglecting centrifugal tension) will be equal to (Where, Pc is centrifugal tension) P1 - P2 ⅟₂ × (P1 + P2) P1 + P2 [⅟₂ × (P1 + P2)] + Pc P1 - P2 ⅟₂ × (P1 + P2) P1 + P2 [⅟₂ × (P1 + P2)] + Pc ANSWER DOWNLOAD EXAMIANS APP
Machine Design The draw of cotter should not be more than 6 mm 3 mm 12 mm 8 mm 6 mm 3 mm 12 mm 8 mm ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS