Machine Design Coaxing is the procedure of increasing Metal strength by cycling Metal resistance to corrosion by coating Metal hardness by surface treatment Fatigue limit by over-stressing the metal by successively increasing loadings Metal strength by cycling Metal resistance to corrosion by coating Metal hardness by surface treatment Fatigue limit by over-stressing the metal by successively increasing loadings ANSWER DOWNLOAD EXAMIANS APP
Machine Design Cast iron pipes are mainly used All of these For conveying steam In water and sewage systems In pressure lubrication systems on prime movers All of these For conveying steam In water and sewage systems In pressure lubrication systems on prime movers ANSWER DOWNLOAD EXAMIANS APP
Machine Design While designing a screw in a screw jack against buckling failure, the end conditions for the screw are taken as Both the ends fixed Both the ends hinged One end fixed and the other end hinged One end fixed and the other end free Both the ends fixed Both the ends hinged One end fixed and the other end hinged One end fixed and the other end free ANSWER DOWNLOAD EXAMIANS APP
Machine Design If a shaft made from ductile material is subjected to combined bending and twisting moment, calculations based on which one of the following failure theories will give the most conservative value? Maximum distortion energy theory Maximum principal stress theory Maximum strain energy theory Maximum shear stress theory Maximum distortion energy theory Maximum principal stress theory Maximum strain energy theory Maximum shear stress theory ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to fluctuating loads for which the normal torque (T) and bending moment (M) are 1000 N-m and 500 N-m respectively. If the combined shock and fatigue factor for bending is 1.5 and combined shock and fatigue factor for torsion is 2, then the equivalent twisting moment for the shaft is 2100 N-m 2000 N-m 2050 N-m 2136 N-m 2100 N-m 2000 N-m 2050 N-m 2136 N-m ANSWER DOWNLOAD EXAMIANS APP
Machine Design The expression 0.175 - 0.841/T is the Lewis form factor for None of these 20° full depth involute system 20° stub system 14½° composite and full depth involute system None of these 20° full depth involute system 20° stub system 14½° composite and full depth involute system ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS