Machine Design Soderberg relation is based on __________ of the material whereas all other failure relation for dynamic loading are based on ultimate strength of the material. Shear strength None of these Yield strength Elastic strength Shear strength None of these Yield strength Elastic strength ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to fluctuating loads for which the normal torque (T) and bending moment (M) are 1000 N-m and 500 N-m respectively. If the combined shock and fatigue factor for bending is 1.5 and combined shock and fatigue factor for torsion is 2, then the equivalent twisting moment for the shaft is 2050 N-m 2100 N-m 2136 N-m 2000 N-m 2050 N-m 2100 N-m 2136 N-m 2000 N-m ANSWER DOWNLOAD EXAMIANS APP
Machine Design The creep in the belt is due to Unequal extensions in the belt due to tight and slack side tensions Stresses beyond elastic limit of belt material Effect of temperature on belt Material of belt Unequal extensions in the belt due to tight and slack side tensions Stresses beyond elastic limit of belt material Effect of temperature on belt Material of belt ANSWER DOWNLOAD EXAMIANS APP
Machine Design The edges of the plates for cylindrical vessels are usually bevelled to an angle of 80° for Ease of manufacture Reducing stress concentration Safety Fullering and caulking Ease of manufacture Reducing stress concentration Safety Fullering and caulking ANSWER DOWNLOAD EXAMIANS APP
Machine Design A circular shaft can transmit a torque of 5 kN-m. If the torque is reduced to 4 kN-m, then the maximum value of bending moment that can be applied to the shaft is 4 kN-m 1 kN-m 3 kN-m 2 kN-m 4 kN-m 1 kN-m 3 kN-m 2 kN-m ANSWER DOWNLOAD EXAMIANS APP
Machine Design Two rigid plates are clamped by means of bolt and nut with an initial force F. After tightening, a separating force P (P < F) is applied to the lower plate, which in turn acts on the nut. The tension in the both after this is F.P F P F + P F.P F P F + P ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS