Manufacturing And Production Technology In reaming process High dimensional accuracy is obtained Metal removal rate is high High surface finish is obtained High form accuracy is obtained High dimensional accuracy is obtained Metal removal rate is high High surface finish is obtained High form accuracy is obtained ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In a plain milling machine, the table can be moved All of these Crosswise Vertically Longitudinally All of these Crosswise Vertically Longitudinally ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In _________ operation, the cutting force is maximum when the tooth begins its cut and reduces it to minimum when the tooth leaves the work. End milling Down milling Face milling Up milling End milling Down milling Face milling Up milling ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Side relief angle of a single point tool is the angle Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool By which the face of the tool is inclined towards back Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base By which the face of the tool is inclined sideways Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool By which the face of the tool is inclined towards back Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base By which the face of the tool is inclined sideways ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In order to have interference fit, it is essential that the lower limit of the shaft should be Lesser than the upper limit of the hole Lesser than the lower limit of the hole Greater than the upper limit of the hole Greater than the lower limit of the hole Lesser than the upper limit of the hole Lesser than the lower limit of the hole Greater than the upper limit of the hole Greater than the lower limit of the hole ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology When two main plates are kept in alignment butting each other and riveted with cover plate on both sides of the main plates with two rows of rivets in each main plate, the joint is known as _______ double cover butt joint. Both (A) and (B) Single riveted None of these Double riveted Both (A) and (B) Single riveted None of these Double riveted ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS