Manufacturing And Production Technology In hot machining, the work is heated by Simple heating Induction heating Any one of these Flame heating Simple heating Induction heating Any one of these Flame heating ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Crater wear occurs mainly on the Cutting edge only Face of the cutting tool at a short distance from the cutting edge only Nose part, front relief face and side relief face of the cutting tool Front face only Cutting edge only Face of the cutting tool at a short distance from the cutting edge only Nose part, front relief face and side relief face of the cutting tool Front face only ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In orthogonal turning of a low carbon steel bar of diameter 150 mm with uncoated carbide tool, the cutting velocity is 90 m/min. The feed is 0.24 mm/rev and the depth of cut is 2 mm. The chip thickness obtained is 0.48 mm. If the orthogonal rake angle is zero and the principle cutting edge angle is 90⁰, the shear angle in degree is 30.56 36.56 26.56 20.56 30.56 36.56 26.56 20.56 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Which of the following parameters govern the value of shear angle in continuous chip formation? All of the listed here Rake angle of the cutting tool True feed Chip thickness All of the listed here Rake angle of the cutting tool True feed Chip thickness ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Crater wear is mainly due to the phenomenon known as Oxidation of metals Diffusion of metals All of these Adhesion of metals Oxidation of metals Diffusion of metals All of these Adhesion of metals ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In an interchangeable assembly, shafts of size 25.000 -0.010⁺⁰∙⁰⁴⁰ mm mate with holes of size 25.000 -0.020⁺⁰∙⁰³⁰, the maximum interference (in microns) in the assembly is 10 30 20 40 10 30 20 40 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS