Manufacturing And Production Technology During normalizing process of steel, the specimen is heated Between the upper and lower critical temperature and cooled in furnace. Above the upper critical temperature and cooled in furnace. Above the upper critical temperature and cooled in still air. Between the upper and lower critical temperature and cooled in still air. Between the upper and lower critical temperature and cooled in furnace. Above the upper critical temperature and cooled in furnace. Above the upper critical temperature and cooled in still air. Between the upper and lower critical temperature and cooled in still air. ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In American Standard Association (ASA) system, if the tool nomenclature is 8-6-5-5-10-15-2 mm, then the side rake angle will be 5° 8° 6° 10° 5° 8° 6° 10° ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In oblique cutting system, the cutting edge of the tool May or may not clear the width of the workpiece May not clear the width of the workpiece Should always clear the width of the workpiece May clear the width of the workpiece May or may not clear the width of the workpiece May not clear the width of the workpiece Should always clear the width of the workpiece May clear the width of the workpiece ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology With the same tool life, the maximum material per minute is removed by Increasing the depth of cut Increasing the cutting speed Decreasing the cutting speed Increasing the feed rate Increasing the depth of cut Increasing the cutting speed Decreasing the cutting speed Increasing the feed rate ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The parameter which completely defines the chip formation in a metal cutting process is Shear angle Both (A) and (B) Chip-tool contact length None of these Shear angle Both (A) and (B) Chip-tool contact length None of these ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Calculate the weld per minute, work speed of circular electrode of 220 mm diameter for carrying out seam welding at 4 welds per cm on 1.6 mm thick mild steel tube. Welding cycle consists of 3 cycles ‘on’ and 2 cycles ‘off’ Power supply is at 50 Hz. 3000 welds/min, 75 mm/min 22 welds/min, 55 mm/min 600 welds/min, 1500 mm/min 500 welds/min, 1250 mm/min 3000 welds/min, 75 mm/min 22 welds/min, 55 mm/min 600 welds/min, 1500 mm/min 500 welds/min, 1250 mm/min ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS