Manufacturing And Production Technology The capacity of a material to be welded under the imposed fabrication conditions into a specific, suitably designed structure and to perform satisfactorily in the intended service is known as? Weld tab Weldment Tack weld Weldability Weld tab Weldment Tack weld Weldability ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Which of the following statement is wrong as regard to down milling? It can not be used on old machines due to backlash between the feed screw of the table and the nut. The coolant can be poured directly at the cutting zone where the cutting force is maximum. The chips are disposed off easily and do not interfere with the cutting. The surface milled appears to be slightly wavy. It can not be used on old machines due to backlash between the feed screw of the table and the nut. The coolant can be poured directly at the cutting zone where the cutting force is maximum. The chips are disposed off easily and do not interfere with the cutting. The surface milled appears to be slightly wavy. ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The addition of lead, sulphur and phosphorus to low carbon steels, help to Break up chips Improve machinability Reduce built up edge All of these Break up chips Improve machinability Reduce built up edge All of these ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The point angle of a drill, for drilling stainless steel, is 135° 90° 118° 150° 135° 90° 118° 150° ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The advantage of a broaching operation is that All of the listed here Roughing and finishing cuts are completed in one pass of the tool Rate of production is very high High accuracy and high class of surface finish is possible All of the listed here Roughing and finishing cuts are completed in one pass of the tool Rate of production is very high High accuracy and high class of surface finish is possible ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The tail-stock set over required to turn a taper on the entire length of a workpiece having diameters D and d is (D - d)/2 (D - d)/2L (D - d)/L D - d (D - d)/2 (D - d)/2L (D - d)/L D - d ANSWER DOWNLOAD EXAMIANS APP