Manufacturing And Production Technology The width of cutting edge of a parting off tool varies from 3 to 12 mm 8 to 30 mm 5 to 20 mm 15 to 40 mm 3 to 12 mm 8 to 30 mm 5 to 20 mm 15 to 40 mm ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The angle on which the strength of the tool depends is Cutting angle Clearance angle Rake angle Lip angle Cutting angle Clearance angle Rake angle Lip angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The rear teeth of a broach Remove minimum metal Perform burnishing operation Remove maximum metal Remove no metal Remove minimum metal Perform burnishing operation Remove maximum metal Remove no metal ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In a metal arc welding process, a gas metal arc welding with magnetized flux is used and can be done in all the positions i.e. flat position, vertical position or inclined position. GMAW practice Dip transfer Globular transfer Spray transfer GMAW practice Dip transfer Globular transfer Spray transfer ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In orthogonal turning of a low carbon steel bar of diameter 150 mm with uncoated carbide tool, the cutting velocity is 90 m/min. The feed is 0.24 mm/rev and the depth of cut is 2 mm. The chip thickness obtained is 0.48 mm. If the orthogonal rake angle is zero and the principle cutting edge angle is 90⁰, the shear angle in degree is 36.56 20.56 30.56 26.56 36.56 20.56 30.56 26.56 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology What is the welding defect caused due to improper control and poor removal of slog between passes called? Mismatch Porosity Under fill Crack Mismatch Porosity Under fill Crack ANSWER DOWNLOAD EXAMIANS APP