Manufacturing And Production Technology In drilling brass, a drill with Any helix angle can be used Zero helix angle is used Low helix angle is used High helix angle is used Any helix angle can be used Zero helix angle is used Low helix angle is used High helix angle is used ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology When 3-2-1 principle is used to support and locate a three dimensional work-piece during machining, the number of degrees of freedom that are restricted is 9 8 10 7 9 8 10 7 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Friction at the tool-chip interface can be reduced by Decreasing the cutting speed Increasing the cutting speed Decreasing the rake angle Increasing the depth of cut Decreasing the cutting speed Increasing the cutting speed Decreasing the rake angle Increasing the depth of cut ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology If a particular Fe-C alloy contains less than 0.83% carbon, it is called Hypo eutectoid steel Hyper eutectoid steel Cast iron High speed steel Hypo eutectoid steel Hyper eutectoid steel Cast iron High speed steel ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The type of reamer used for reaming operation in a blind hole, is Straight fluted reamer Right hand spiral fluted reamer Left hand spiral fluted reamer Any one of these Straight fluted reamer Right hand spiral fluted reamer Left hand spiral fluted reamer Any one of these ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A lathe with four steps on the cone pulley and with back-gears will have Four indirect speeds Four direct speeds Four direct and four indirect speeds Eight indirect speeds Four indirect speeds Four direct speeds Four direct and four indirect speeds Eight indirect speeds ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS