Manufacturing And Production Technology Chip breakers are used to Break the chips into short segments Remove chips from bed Increase tool life To minimize heat generation Break the chips into short segments Remove chips from bed Increase tool life To minimize heat generation ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The lathe centres are provided with standard taper known as Chapman taper Brown and Sharpe taper Morse taper Seller's taper Chapman taper Brown and Sharpe taper Morse taper Seller's taper ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A hole is of dimension φ = 9 ₊0⁺⁰∙⁰¹⁵ mm. The corresponding shaft is of dimension φ = 9 ₊0.001⁺⁰∙⁰¹⁰ mm. The resulting assembly has Loose running fit Interference fit Transition fit Close running fit Loose running fit Interference fit Transition fit Close running fit ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Side relief angle of a single point tool is the angle By which the face of the tool is inclined sideways Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool By which the face of the tool is inclined towards back By which the face of the tool is inclined sideways Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool By which the face of the tool is inclined towards back ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Broaching is applied for machining External flat and contoured surfaces Internal and external surfaces Round or irregular shaped holes All of these External flat and contoured surfaces Internal and external surfaces Round or irregular shaped holes All of these ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A solid cylinder of diameter 100 mm and height 50 mm is forged between two frictionless flat dies to a height of 25 mm. The percentage change in diameter is 20.7 2.07 41.4 20.7 2.07 41.4 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS