Machine Design In a partial journal bearing, the angle of contact of the bearing with the journal is 360° 180° 120° 270° 360° 180° 120° 270° ANSWER DOWNLOAD EXAMIANS APP
Machine Design The usual proportion for the width of key is (where d = Diameter of shaft or diameter of hole in the hub) d/6 d/8 d/4 d/2 d/6 d/8 d/4 d/2 ANSWER DOWNLOAD EXAMIANS APP
Machine Design When two non-parallel or intersecting but coplanar shafts are connected by gears, the arrangement is known as, Bevel gearing Worm gearing Helical gearing None of these Bevel gearing Worm gearing Helical gearing None of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design In order to remove internal stresses produced by hardening the steel, the process usually adopted is Annealing Spheroidizing Tempering Normalizing Annealing Spheroidizing Tempering Normalizing ANSWER DOWNLOAD EXAMIANS APP
Machine Design In designing a sleeve coupling, outer diameter of the sleeve is taken as (where d = Diameter of the shaft) 3.5d 2d + 20 mm 2d + 13 mm d + 17 mm 3.5d 2d + 20 mm 2d + 13 mm d + 17 mm ANSWER DOWNLOAD EXAMIANS APP
Machine Design Two shafts of the same length and material are joined in series. If the ratio of their diameters is 2, then the ratio of their angles of twist will be 4 16 2 8 4 16 2 8 ANSWER DOWNLOAD EXAMIANS APP