Power Systems In a 400 KV network, 360 KV is recorded at a 400 KV bus. The reactive power absorbed by shunt rated for 50 MVAr, 400 KV connected at the bus is 61.73 MVAr. 40.5 MVAr. 45 MVAr. 55.56 MVAr. 61.73 MVAr. 40.5 MVAr. 45 MVAr. 55.56 MVAr. ANSWER DOWNLOAD EXAMIANS APP
Power Systems The main objectives of electrical power transmission is/are both 1 and 2 Transmission system must be more efficient with minimum line losses Voltage regulation of the transmission line must be zero or minimum nether 1 nor 2 both 1 and 2 Transmission system must be more efficient with minimum line losses Voltage regulation of the transmission line must be zero or minimum nether 1 nor 2 ANSWER DOWNLOAD EXAMIANS APP
Power Systems A transmission line has a surge impedance of 400 Ω for a length of the line of 200 km. If the length of line is increased to 400 km, then its surge impedance is 0 Ω 200 Ω 400 Ω 800 Ω 0 Ω 200 Ω 400 Ω 800 Ω ANSWER DOWNLOAD EXAMIANS APP
Power Systems A 3-phase transmission line operating at Vs = 400 kV and has ABCD parameters A= D = 0.8∠0°, B = 100∠90° Ω, C = 0.5*10-6∠90° â„§. Find the no load receiving end voltage? 500 kV 400 kV 600 kV 320 kv 500 kV 400 kV 600 kV 320 kv ANSWER DOWNLOAD EXAMIANS APP
Power Systems A lossless power system has to serve a load of 250 MW. There are two generators(G1 and G2) in the system with cost curves C1 and C2 respectively defined as follows: C1 = PG1+0.055P²G1 C2 = 3 PG2 + 0.03 P²G2 Where PG1 and PG2 are the MW injections from generators G1 and G2 respectively. Thus, the minimum cost dispatch will be PG1 = 250 MW and PG2 = 0 MW PG1 = 150 MW and PG2 = 100 MW PG1 = 0 MW and PG2 = 250 MW PG1 = 100 MW and PG2 = 150 MW PG1 = 250 MW and PG2 = 0 MW PG1 = 150 MW and PG2 = 100 MW PG1 = 0 MW and PG2 = 250 MW PG1 = 100 MW and PG2 = 150 MW ANSWER DOWNLOAD EXAMIANS APP
Power Systems Capacitance voltage transformer ( CVT ) is used to reduce losses in a transmission line. improve the power factor of the transmission. none of these. connect instruments on the LT side. reduce losses in a transmission line. improve the power factor of the transmission. none of these. connect instruments on the LT side. ANSWER DOWNLOAD EXAMIANS APP