Analog Electronics Ignoring the bulk resistance of the collector diode, the collector-emitter saturation voltage is supply voltage. 0. 1 V. a few tenths of a volt. supply voltage. 0. 1 V. a few tenths of a volt. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics The transit time of the electric current carriers through the channel of a JFET decides it’s ________________ characteristics. source. source and drain. drain. gate. source. source and drain. drain. gate. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics Which of following is the point of reference JFET? Source. None of above. Drain. Gate. Source. None of above. Drain. Gate. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics When a junction diode is Reverse Biased then diode acts like ....................... Close switch Short switch An open switch None of these Close switch Short switch An open switch None of these ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics To prevent a DC return between source and load, it is necessary to use Either A or B Inductor between source and load Resistor between source and load Capacitor between source and load Either A or B Inductor between source and load Resistor between source and load Capacitor between source and load ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed 39.5mV 795mV 79.5 mV 395mV 39.5mV 795mV 79.5 mV 395mV ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS