Analog Electronics Which of the following components are used for bias compensation in transistor circuit? Resistors. Thermistor. Both (A) and (C) above. Rectifier diodes. Resistors. Thermistor. Both (A) and (C) above. Rectifier diodes. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed 795mV 395mV 79.5 mV 39.5mV 795mV 395mV 79.5 mV 39.5mV ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics When testing an npn transistor using an ohmmeter, the collector-emitter resistance will be low when the transistor is defective. the emitter is positive in respect to the collector. the collector is positive in respect to the emitter. the transistor is normal. the transistor is defective. the emitter is positive in respect to the collector. the collector is positive in respect to the emitter. the transistor is normal. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics The softness factor for soft recovery and fast recovery diodes are respectively 1, 1, >1. 1, 1. 1, 1, >1. 1, 1. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics Silicon has eight valence electrons. two valence electrons. none of above. four valence electrons. eight valence electrons. two valence electrons. none of above. four valence electrons. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics When a reverse bias is applied to a diode, it will raise the potential barrier. increases the majority carrier an electric current greatly. lower the potential barrier. none of these. raise the potential barrier. increases the majority carrier an electric current greatly. lower the potential barrier. none of these. ANSWER DOWNLOAD EXAMIANS APP