Machine Design According to Indian standards, the diameter of rivet hole is made larger than the basic size of rivet by 0.5 mm up to rivet diameter of 24 mm 1 mm for rivet diameter from 27 mm to 36 mm All of these 2 mm for rivet diameter from 39 mm to 48 mm 0.5 mm up to rivet diameter of 24 mm 1 mm for rivet diameter from 27 mm to 36 mm All of these 2 mm for rivet diameter from 39 mm to 48 mm ANSWER DOWNLOAD EXAMIANS APP
Machine Design In designing a connecting rod, it is considered like __________ for buckling about X-axis. Both ends hinged One end fixed and the other end hinged One end fixed and the other end free Both ends fixed Both ends hinged One end fixed and the other end hinged One end fixed and the other end free Both ends fixed ANSWER DOWNLOAD EXAMIANS APP
Machine Design The diameter of the rivet hole is usually __________ the nominal diameter of the rivet. Less than None of these Equal to More than Less than None of these Equal to More than ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to a maximum bending stress of 80 N/mm² and maximum shearing stress equal to 30 N/mm² at a particular section. If the yield point in tension of the material is 280 N/mm² and the maximum shear stress theory of failure is used, then the factor of safety obtained will be 3.5 2.5 2.8 3.0 3.5 2.5 2.8 3.0 ANSWER DOWNLOAD EXAMIANS APP
Machine Design Which is positive drive? Timing belt Crossed belt drive V belt drive Flat belt drive Timing belt Crossed belt drive V belt drive Flat belt drive ANSWER DOWNLOAD EXAMIANS APP
Machine Design A universal coupling is used to connect two shafts Whose axes intersect at a small angle Have lateral misalignment Which are perfectly aligned Which are not in exact alignment Whose axes intersect at a small angle Have lateral misalignment Which are perfectly aligned Which are not in exact alignment ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS