Machine Design According to I.B.R., the thickness of the boiler shell should not be less than 6 mm 7 mm 4 mm 5 mm 6 mm 7 mm 4 mm 5 mm ANSWER DOWNLOAD EXAMIANS APP
Machine Design If T₁ and T₂ are the tensions on the tight and slack sides of the belt respectively, and Tc is the centrifugal tension, then initial tension in the belt is equal to (T₁ - T₂ + Tc)/2 T₁ - T₂ + Tc (T₁ + T₂ + Tc)/2 T₁ + T₂ + Tc (T₁ - T₂ + Tc)/2 T₁ - T₂ + Tc (T₁ + T₂ + Tc)/2 T₁ + T₂ + Tc ANSWER DOWNLOAD EXAMIANS APP
Machine Design Cast iron pipes are mainly used For conveying steam All of these In water and sewage systems In pressure lubrication systems on prime movers For conveying steam All of these In water and sewage systems In pressure lubrication systems on prime movers ANSWER DOWNLOAD EXAMIANS APP
Machine Design Which of the following key is preferred for the condition when a large amount of impact type torque is to be transmitted in both direction of rotation? Woodruff key Feather key Gib-head key Tangent key Woodruff key Feather key Gib-head key Tangent key ANSWER DOWNLOAD EXAMIANS APP
Machine Design Two rigid plates are clamped by means of bolt and nut with an initial force F. After tightening, a separating force P (P < F) is applied to the lower plate, which in turn acts on the nut. The tension in the both after this is F F + P P F.P F F + P P F.P ANSWER DOWNLOAD EXAMIANS APP
Machine Design In nitrated parts, the origins of the fatigue cracks will occur at Just below the surface Surface None of these Within the core Just below the surface Surface None of these Within the core ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS