Machine Design A metal pipe of 1 m diameter contains a fluid having a pressure of 1 N/mm². If the permissible tensile stress in the metal is 20 N/mm², then the thickness of the metal required for making the pipe will be 10 mm 5 mm 15 mm 25 mm 10 mm 5 mm 15 mm 25 mm ANSWER DOWNLOAD EXAMIANS APP
Machine Design If T₁ and T₂ are the tensions on the tight and slack sides of the belt respectively, and Tc is the centrifugal tension, then initial tension in the belt is equal to (T₁ - T₂ + Tc)/2 T₁ + T₂ + Tc T₁ - T₂ + Tc (T₁ + T₂ + Tc)/2 (T₁ - T₂ + Tc)/2 T₁ + T₂ + Tc T₁ - T₂ + Tc (T₁ + T₂ + Tc)/2 ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a partial journal bearing, the angle of contact of the bearing with the journal is 120° 180° 270° 360° 120° 180° 270° 360° ANSWER DOWNLOAD EXAMIANS APP
Machine Design The efficiency of a square threaded screw is maximum if the helix angle is equal to(Where φ = Angle of friction) 45° - φ 90° - φ 45° - φ/2 45° + φ/2 45° - φ 90° - φ 45° - φ/2 45° + φ/2 ANSWER DOWNLOAD EXAMIANS APP
Machine Design The cross-section of the arm of a bell crank lever is I-section Elliptical Any one of these Rectangular I-section Elliptical Any one of these Rectangular ANSWER DOWNLOAD EXAMIANS APP
Machine Design The ratio of driving tensions in V-belt drives is __________ flat belt drives. cosec α times more than sin α times more than sin α times less than Equal to cosec α times more than sin α times more than sin α times less than Equal to ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS