Process Equipment and Plant Design A binary liquid azeotropic mixture has boiling point lower than either of the components, when it shows __________ deviation from Raoult's Law. Negative None of these No Positive Negative None of these No Positive ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design Width and depth of grooves in the tube sheet holes normally are __________ inch respectively. 1/64 and 1/8 1/2 and 5 1/8 and 1/64 1/2 and 8 1/64 and 1/8 1/2 and 5 1/8 and 1/64 1/2 and 8 ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design In the case of a shell and tube heat exchanger, the logarithmic mean temperature difference Is always less than arithmetic average value Is always less than arithmetic mean value, but more than geometric mean value Is always more than arithmetic mean value and the geometric mean value May be either more or less than geometric mean and arithmetic mean value depending upon whether the flow of stream is co-current or counter-current Is always less than arithmetic average value Is always less than arithmetic mean value, but more than geometric mean value Is always more than arithmetic mean value and the geometric mean value May be either more or less than geometric mean and arithmetic mean value depending upon whether the flow of stream is co-current or counter-current ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design Flanges are connected to pipes by Welding All of these Brazing Screwing Welding All of these Brazing Screwing ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design Weep holes provided in the plates of a distillation column Are normally located near the overflow weir so that any delivery of liquid during operation follows approximately the same path as the overflow fluid Facilitate draining out liquid from a tray when the unit is not in operation All of these Must be large enough (usually 1/4" to 5/8" dia) to prevent plugging but should not deliver excessive amount of fluid during operation Are normally located near the overflow weir so that any delivery of liquid during operation follows approximately the same path as the overflow fluid Facilitate draining out liquid from a tray when the unit is not in operation All of these Must be large enough (usually 1/4" to 5/8" dia) to prevent plugging but should not deliver excessive amount of fluid during operation ANSWER DOWNLOAD EXAMIANS APP
Process Equipment and Plant Design For a cylinderical vessel of moderate height, the weld joint efficiency for joints parallel to the cylinderical axis is given as 1.0, while for joints along the girth (circumference) it is given as 0.8. In calculating the shell wall thickness using code formula for an internally pressurised cylinderical vessel, what value of weld joint efficiency should be used? 0.9 1 (0.8)0.5 0.8 0.9 1 (0.8)0.5 0.8 ANSWER DOWNLOAD EXAMIANS APP