Heat Transfer Which of the following has maximum thermal conductivity? Nitrogen Iron Tar Coal Nitrogen Iron Tar Coal ANSWER DOWNLOAD EXAMIANS APP
Heat Transfer Which of the following situations can be approximated to a steady state heat transfer system? A sub-cooled refrigerant liquid at 8°C flowing at the rate of 6 Kg/minute through a copper pipe exposed to atmospheric air at 35°C 10 kg of dry saturated steam at 8 kgf/cm² flowing through a short length of stainless steel pipe exposed to atmospheric air at 35°C A red hot steel slab (having outside surface temperature as 1300°C) exposed to the atmosheric air at 35°C Boiling brine kept in open vessel when the bottom surface temperature of the vessel is maintained constant at 180°C A sub-cooled refrigerant liquid at 8°C flowing at the rate of 6 Kg/minute through a copper pipe exposed to atmospheric air at 35°C 10 kg of dry saturated steam at 8 kgf/cm² flowing through a short length of stainless steel pipe exposed to atmospheric air at 35°C A red hot steel slab (having outside surface temperature as 1300°C) exposed to the atmosheric air at 35°C Boiling brine kept in open vessel when the bottom surface temperature of the vessel is maintained constant at 180°C ANSWER DOWNLOAD EXAMIANS APP
Heat Transfer In a laboratory test run, the rate of drying was found to be 0.5 x 10-3 kg/m².s, when the moisture content reduced from 0.4 to 0.1 on dry basis. The critical moisture content of the material is 0.08 on a dry basis. A tray dryer is used to dry 100 kg (dry basis) of the same material under identical conditions. The surface area of the material is 0.04 m²/kg of dry solid. The time required (in seconds) to reduce the moisture content of the solids from 0.3 to 0.2 (dry basis) is 4000 2000 6000 5000 4000 2000 6000 5000 ANSWER DOWNLOAD EXAMIANS APP
Heat Transfer Thermal diffusivity of a material All of these Is the ratio of thermal conductivity to thermal capacity Has the unit m² /sec Is defined as K/ρ . Cp All of these Is the ratio of thermal conductivity to thermal capacity Has the unit m² /sec Is defined as K/ρ . Cp ANSWER DOWNLOAD EXAMIANS APP
Heat Transfer Circulation pump is located below the evaporater to Avoid frequent priming Avoid cavitation None of these Create more suction head Avoid frequent priming Avoid cavitation None of these Create more suction head ANSWER DOWNLOAD EXAMIANS APP
Heat Transfer __________ paint has the minimum absorption co-efficient. Grey White lead Black Light cream Grey White lead Black Light cream ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS