Engineering Drawing This line pattern is composed of three dashes, one long dash on each end with a short dash in the middle: Hidden Object Center Phantom Hidden Object Center Phantom ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing This is a rounded exterior blend between surfaces: Round Fillet Taper Chamfer Round Fillet Taper Chamfer ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Given a situation in which the drafter has crossed extension lines in a drawing what can be done to clean up the point of crossing? Use the Tolerance tool to clean up the extension lines Use the Modify tool to clean up the extension lines Use the stretch tool to clean up the extension lines Use the Break tool to clean up the extension lines Use the Tolerance tool to clean up the extension lines Use the Modify tool to clean up the extension lines Use the stretch tool to clean up the extension lines Use the Break tool to clean up the extension lines ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Once the architect has finalized the house plans with the client any changes to the design requested by the client will require a ________. Whole new set of drawings Change order None of these Modification slip Whole new set of drawings Change order None of these Modification slip ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing Using the Relative Polar Coordinate System to add a 3 inch line that is 45 degrees from the end point of the line created above the drafter would ________. Type @3 Type 3 and try to use the Dynamic Input readout to find the end point Type 3 forward slash and enter Type 3 back slash and enter Type @3 Type 3 and try to use the Dynamic Input readout to find the end point Type 3 forward slash and enter Type 3 back slash and enter ANSWER DOWNLOAD EXAMIANS APP
Engineering Drawing An engineer's scale would be used to measure lines on a drawing where the scale factor reads ________. 1" = 100' 1/8" = 1'-0" 3/4" = 1'-0" 1/4" = 1'-0" 1" = 100' 1/8" = 1'-0" 3/4" = 1'-0" 1/4" = 1'-0" ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS