Manufacturing And Production Technology The process of removing metal by a cutter which is rotated in the same direction of travel of workpiece, is called Up milling End milling Face milling Down milling Up milling End milling Face milling Down milling ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Larger than 15° side cutting edge angle Results in excessive stress concentration and greater heat generation Produces chipping and decreases tool life Increases tool life Decreases tool life Results in excessive stress concentration and greater heat generation Produces chipping and decreases tool life Increases tool life Decreases tool life ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In ___ operation, the chip thickness is minimum at the beginning of the cut and it reaches to the maximum when the cut terminates. Face milling End milling Conventional milling Climb milling Face milling End milling Conventional milling Climb milling ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In an orthogonal cutting, the depth of cut is halved and the feed rate is double. If the chip thickness ratio is unaffected with the changed cutting conditions, the actual chip thickness will be Unchanged Halved Quadrupled Doubled Unchanged Halved Quadrupled Doubled ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Which of the following statement is wrong as regard to down milling? The surface milled appears to be slightly wavy. The chips are disposed off easily and do not interfere with the cutting. It can not be used on old machines due to backlash between the feed screw of the table and the nut. The coolant can be poured directly at the cutting zone where the cutting force is maximum. The surface milled appears to be slightly wavy. The chips are disposed off easily and do not interfere with the cutting. It can not be used on old machines due to backlash between the feed screw of the table and the nut. The coolant can be poured directly at the cutting zone where the cutting force is maximum. ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Side relief angle of a single point tool is the angle Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool By which the face of the tool is inclined sideways Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base By which the face of the tool is inclined towards back Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool By which the face of the tool is inclined sideways Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base By which the face of the tool is inclined towards back ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS