Manufacturing And Production Technology The tool life is said to be over if Overheating and fuming due to heat of friction starts All of these There is sudden increase in cutting forces and power consumption Poor surface finish is obtained Overheating and fuming due to heat of friction starts All of these There is sudden increase in cutting forces and power consumption Poor surface finish is obtained ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology If the cutting speed is increased, then the built-up-edge May or may not form Becomes longer Has nothing to do with speed Becomes smaller and finally does not form at all May or may not form Becomes longer Has nothing to do with speed Becomes smaller and finally does not form at all ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology With the same tool life, the maximum material per minute is removed by Increasing the cutting speed Decreasing the cutting speed Increasing the depth of cut Increasing the feed rate Increasing the cutting speed Decreasing the cutting speed Increasing the depth of cut Increasing the feed rate ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The tool made of cemented carbide wear out faster at Very fast speeds Medium speeds Fast speeds Slow speeds Very fast speeds Medium speeds Fast speeds Slow speeds ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The percentage of carbon in gray cast iron is in the range of 1.25 to 1.75 percent 3 to 4 percent 0.25 to 0.75 percent 8 to 10 percent 1.25 to 1.75 percent 3 to 4 percent 0.25 to 0.75 percent 8 to 10 percent ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The abrasive slurry used in ultrasonic machining contains fine particles of All of the listed here Silicon carbide Aluminium oxide Boron carbide All of the listed here Silicon carbide Aluminium oxide Boron carbide ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS