Machine Design The process extensively used for making bolts and nuts is Hot piercing Extrusion Cold peening Cold heading Hot piercing Extrusion Cold peening Cold heading ANSWER DOWNLOAD EXAMIANS APP
Machine Design The surface finish factor for a mirror polished material is 0.85 0.45 0.65 1 0.85 0.45 0.65 1 ANSWER DOWNLOAD EXAMIANS APP
Machine Design The bending stress in a curved beam is Zero at the centroidal axis None of these Maximum at the neutral axis Zero at the point other than centroidal axis Zero at the centroidal axis None of these Maximum at the neutral axis Zero at the point other than centroidal axis ANSWER DOWNLOAD EXAMIANS APP
Machine Design When a bolt and nut is made of mild steel, then the effective height of nut is made equal to (where d = Nominal diameter of bolt) d 1.25 d 0.5 d 0.75 d d 1.25 d 0.5 d 0.75 d ANSWER DOWNLOAD EXAMIANS APP
Machine Design In standard taper roller bearings, the angle of taper of outer raceway is 8° 5° 25° 15° 8° 5° 25° 15° ANSWER DOWNLOAD EXAMIANS APP
Machine Design In order to remove internal stresses produced by hardening the steel, the process usually adopted is Tempering Spheroidizing Normalizing Annealing Tempering Spheroidizing Normalizing Annealing ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS