Measurement and Instrumentation The pressure coil of a wattmeter should be connected on the supply side of the current coil when None of these Supply voltage is low Load impedance is high Load impedance is low None of these Supply voltage is low Load impedance is high Load impedance is low ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The use of __________________ instruments is merely confined within laboratories as standardizing instrument. recording. integrating. indicating. absolute. recording. integrating. indicating. absolute. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The time/div and voltage axes of an oscilloscope have been creased. A student connects a 1 KHz, 5 V P-P square wave calibrition pulse to channel-1 of the scope and observes the screen to be as shown in the upper trace of figure. An unknown signal is connected to channel-2 (lower trace) of the scope. If the time/div and V/div on both channels are the same, the amplitude (P-P) and period of the unknown signal are respectively 7.5 V, 2 ms. 10 V, 1 ms. 5 V, 1 ms. 5 V, 2 ms. 7.5 V, 2 ms. 10 V, 1 ms. 5 V, 1 ms. 5 V, 2 ms. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The maximum percentage error in the sum of two voltage measurements when V1 = 100V ± 1% and V2 = 80V ± 5% is ± 4% ± 6% ± 3% ± 2.8% ± 4% ± 6% ± 3% ± 2.8% ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation It is found that 10A current passes through a resistor of 10°hms. The resistor has 5% tolerance . The error in measurement of current can be as high as 5%. What is max error in measurement of power, calculated from measured value of I and the nominal value of resistor? 200W 50W 100W 150W 200W 50W 100W 150W ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation The errors introduced by an instrument fall in which category ? Systematic errors Random errors Gross errors Environmental errors Systematic errors Random errors Gross errors Environmental errors ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS