Measurement and Instrumentation No eddy current and hysteresis losses occur in Moving iron instruments PMMC instruments Electrostatic instruments Electrodynamo meter instruments Moving iron instruments PMMC instruments Electrostatic instruments Electrodynamo meter instruments ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A metal strain gauge has a gauge factor of two. Its nominal resistance is 120 ohms. If it undergoes a strain of 10-5, the value of change of resistance in response to the strain is 0.0024 Ohm. 240 Ohm. 120 Ohm. 0.0012 Ohm. 0.0024 Ohm. 240 Ohm. 120 Ohm. 0.0012 Ohm. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Potentiometer method of DC voltage measurement is more accurate than direct measurement using a voltmeter because It uses centre zero galvanometer instead of voltmeter. It loads the circuit to maximum extent. It does not load the circuit at all. It loads the circuit moderately. It uses centre zero galvanometer instead of voltmeter. It loads the circuit to maximum extent. It does not load the circuit at all. It loads the circuit moderately. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation PMMC type instruments normally use None of these Fluid friction damping Air friction damping Eddy current damping None of these Fluid friction damping Air friction damping Eddy current damping ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation An ammeter of range 0-25 A has a guaranteed accuracy of 1% of full-scale reading. The current measured by the ammeter is 5 A. The limiting error in the reading is 3% 5% 6% 4% 3% 5% 6% 4% ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation For measurement of high direct voltage, one would use _____ voltmeter. Electrostatic PMMC Hot wire Moving iron Electrostatic PMMC Hot wire Moving iron ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS