Machine Design The power transmitted by belt drive depends upon Belt velocity Initial belt tension Arc of contact All of these Belt velocity Initial belt tension Arc of contact All of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a band and block brake, the ratio of tensions on the tight and slack sides of band is given by (where μ = Coefficient of friction between the blocks and the drum, θ = Semi-angle of each block subtending at the centre of drum, and n = Number of blocks) T₁/T₂ = [(1 + μ tanθ)/ (1 - μ tanθ)]n T₁/T₂ = [(1 - μ tanθ)/ (1 + μ tanθ)]n T₁/T₂ = (μθ)n T₁/T₂ = μθ × n T₁/T₂ = [(1 + μ tanθ)/ (1 - μ tanθ)]n T₁/T₂ = [(1 - μ tanθ)/ (1 + μ tanθ)]n T₁/T₂ = (μθ)n T₁/T₂ = μθ × n ANSWER DOWNLOAD EXAMIANS APP
Machine Design When an open coiled helical compression spring is subjected to an axial compressive load, the maximum shear stress induced in the wire is (where D = Mean diameter of the spring coil, d = Diameter of the spring wire, K = Wahl's stress factor, and W = Axial compressive load on the spring) (2WD/ πd3) × K (WD/ πd3) × K (8WD/ πd3) × K (4WD/ πd3) × K (2WD/ πd3) × K (WD/ πd3) × K (8WD/ πd3) × K (4WD/ πd3) × K ANSWER DOWNLOAD EXAMIANS APP
Machine Design A column of length l is fixed at both ends. The equivalent length of the column is l/√2 l 2 l l/2 l/√2 l 2 l l/2 ANSWER DOWNLOAD EXAMIANS APP
Machine Design In case of V belt drive None of these The belt should touch the bottom of groove in the pulley The belt should not touch the bottom of groove in the pulley The belt should not touch the sides of groove in the pulley None of these The belt should touch the bottom of groove in the pulley The belt should not touch the bottom of groove in the pulley The belt should not touch the sides of groove in the pulley ANSWER DOWNLOAD EXAMIANS APP
Machine Design The constant factor in case of R10 series of preferred numbers is 1.58 1.12 1.06 1.26 1.58 1.12 1.06 1.26 ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS