Workshop Technology The maximum flame temperature occurs At the outer cone Between the outer and inner cone At the torch tip At the inner cone At the outer cone Between the outer and inner cone At the torch tip At the inner cone ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Tandem drawing of wires and tubes is necessary because Annealing is needed between stages Accuracy in dimensions is not possible otherwise Surface finish improves after every drawing stage It is not possible to reduce at one stage Annealing is needed between stages Accuracy in dimensions is not possible otherwise Surface finish improves after every drawing stage It is not possible to reduce at one stage ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Which of the following welding process uses non-consumable electrodes? Manual arc welding Submerged arc welding MIG welding TIG welding Manual arc welding Submerged arc welding MIG welding TIG welding ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For obtaining a cup of diameter 25 mm and height 15 mm by drawing, the size of the round blank should be approximately 48 mm 44 mm 46 mm 42 mm 48 mm 44 mm 46 mm 42 mm ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology According to Indian standards, the total numbers of tolerance grades are 12 18 20 8 12 18 20 8 ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The width of slot cut by a hacksaw blade is ___ the width of the blade. Greater than Less than None of the listed here Equal to Greater than Less than None of the listed here Equal to ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS