Workshop Technology The fullers are used For necking down a piece of work For punching a hole For finishing flat surfaces To finish the punched hole For necking down a piece of work For punching a hole For finishing flat surfaces To finish the punched hole ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In forehand welding, the angle between the welding torch and the work is ________ as compared to backhand welding. Same Less None of these More Same Less None of these More ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The process of increasing the cross-section of a bar at the expense of its length, is called Peening Spinning Upsetting Drawing down Peening Spinning Upsetting Drawing down ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The width of slot cut by a hacksaw blade is ___ the width of the blade. Greater than None of the listed here Equal to Less than Greater than None of the listed here Equal to Less than ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The oxygen cylinder is usually painted with Yellow colour White colour Maroon colour Black colour Yellow colour White colour Maroon colour Black colour ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The temperature at which the new grains are formed in the metal is called Recrystallisation temperature Lower critical temperature Upper critical temperature Eutectic temperature Recrystallisation temperature Lower critical temperature Upper critical temperature Eutectic temperature ANSWER DOWNLOAD EXAMIANS APP