Manufacturing And Production Technology The crystal structure of austenite is Body centered tetragonal Hexagonal closed packed Body centered cubic Face centered cubic Body centered tetragonal Hexagonal closed packed Body centered cubic Face centered cubic ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology With the same tool life, the maximum material per minute is removed by Increasing the feed rate Increasing the depth of cut Increasing the cutting speed Decreasing the cutting speed Increasing the feed rate Increasing the depth of cut Increasing the cutting speed Decreasing the cutting speed ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The tool may fail due to All of these Plastic deformation of the cutting edge Cracking at the cutting edge due to thermal stresses Chipping of the cutting edge All of these Plastic deformation of the cutting edge Cracking at the cutting edge due to thermal stresses Chipping of the cutting edge ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology What is the type of welding defect caused due to poor manipulation of weld rod or a dirty joint called? Porosity Under fill Crack Undercut Porosity Under fill Crack Undercut ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The point angle of a drill, for drilling stainless steel, is 135° 90° 150° 118° 135° 90° 150° 118° ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A drill bit of 20 mm diameter rotating at 500 r.p.m. with a feed rate of 0.2 mm/revolution is used to drill a through hole in a mild steel plate 20 mm thickness. The depth of cut in this drilling operation is 10 mm 0.2 mm 100 mm 20 mm 10 mm 0.2 mm 100 mm 20 mm ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS