Machine Design The creep in the belt is due to Unequal extensions in the belt due to tight and slack side tensions Material of belt Effect of temperature on belt Stresses beyond elastic limit of belt material Unequal extensions in the belt due to tight and slack side tensions Material of belt Effect of temperature on belt Stresses beyond elastic limit of belt material ANSWER DOWNLOAD EXAMIANS APP
Machine Design The usual clearance provided in hydrodynamic bearing per mm of diameter of shaft is 0.1 micron 0.01 micron 1 micron 10 microns 0.1 micron 0.01 micron 1 micron 10 microns ANSWER DOWNLOAD EXAMIANS APP
Machine Design In standard taper roller bearings, the angle of taper of outer raceway is 5° 15° 8° 25° 5° 15° 8° 25° ANSWER DOWNLOAD EXAMIANS APP
Machine Design When the material of key and shaft is same, and the width of key is one-fourth of the diameter of shaft (d), then length of key will be 1.2 d 0.8 d 1.57 d 1.8 d 1.2 d 0.8 d 1.57 d 1.8 d ANSWER DOWNLOAD EXAMIANS APP
Machine Design The width of the pulley should be __________ width of the belt. Equal to Less than Greater than None of these Equal to Less than Greater than None of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design Spring stiffness is Its capability of storing energy Ratio of coil diameter to wire diameter Its ability to absorb shocks Load required to produce unit deflection Its capability of storing energy Ratio of coil diameter to wire diameter Its ability to absorb shocks Load required to produce unit deflection ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS