Machine Design The bending stress in a curved beam is None of these Zero at the point other than centroidal axis Maximum at the neutral axis Zero at the centroidal axis None of these Zero at the point other than centroidal axis Maximum at the neutral axis Zero at the centroidal axis ANSWER DOWNLOAD EXAMIANS APP
Machine Design When the connected members are very yielding (soft gasket) as compared to the bolt, then the resultant load on the bolt will be equal to the Initial tension or external load, whichever is greater Initial tension Sum of the initial tension and external load applied External load applied Initial tension or external load, whichever is greater Initial tension Sum of the initial tension and external load applied External load applied ANSWER DOWNLOAD EXAMIANS APP
Machine Design The dedendum circle diameter is equal to (where φ = Pressure angle) Pitch circle diameter × sinφ Clearance circle diameter × cosφ Pitch circle diameter × cosφ Addendum circle diameter × cosφ Pitch circle diameter × sinφ Clearance circle diameter × cosφ Pitch circle diameter × cosφ Addendum circle diameter × cosφ ANSWER DOWNLOAD EXAMIANS APP
Machine Design The helix angle for single helical gears ranges from 35° to 50° 15° to 20° 10° to 15° 20° to 35° 35° to 50° 15° to 20° 10° to 15° 20° to 35° ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to a maximum bending stress of 80 N/mm² and maximum shearing stress equal to 30 N/mm² at a particular section. If the yield point in tension of the material is 280 N/mm² and the maximum shear stress theory of failure is used, then the factor of safety obtained will be 3.5 2.5 2.8 3.0 3.5 2.5 2.8 3.0 ANSWER DOWNLOAD EXAMIANS APP
Machine Design In standard taper roller bearings, the angle of taper of outer raceway is 5° 8° 15° 25° 5° 8° 15° 25° ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS