Manufacturing And Production Technology Side relief angle of a single point tool is the angle By which the face of the tool is inclined towards back Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool By which the face of the tool is inclined sideways By which the face of the tool is inclined towards back Between the surface of the flank immediately below the point and a line drawn from the point perpendicular to the base Between the surface of the flank immediately below the point and a plane at right angles to the centre line of the point of tool By which the face of the tool is inclined sideways ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology An expendable pattern is used in Investment casting Squeeze casting Slush casting Centrifugal casting Investment casting Squeeze casting Slush casting Centrifugal casting ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The tool made of cemented carbide wear out faster at Fast speeds Medium speeds Slow speeds Very fast speeds Fast speeds Medium speeds Slow speeds Very fast speeds ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In orthogonal turning of a low carbon steel bar of diameter 150 mm with uncoated carbide tool, the cutting velocity is 90 m/min. The feed is 0.24 mm/rev and the depth of cut is 2 mm. The chip thickness obtained is 0.48 mm. If the orthogonal rake angle is zero and the principle cutting edge angle is 90⁰, the shear angle in degree is 30.56 36.56 20.56 26.56 30.56 36.56 20.56 26.56 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A grinding wheel becomes glazed (i.e. cutting edge takes a glass-like appearance) due to Breaking of abrasive grains Wear of bond Cracks on grinding wheel Wear of abrasive grains Breaking of abrasive grains Wear of bond Cracks on grinding wheel Wear of abrasive grains ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In metal cutting, use of low feeds and high cutting speeds is desired when the objective is Dry machining High metal removal rate Use of soft cutting tool Surface finish Dry machining High metal removal rate Use of soft cutting tool Surface finish ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS