Measurement and Instrumentation On a simple ohmmeter, the 0 Ω mark is _______ of the scale. Far left In the middle Far right None of the listed here Far left In the middle Far right None of the listed here ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A metal strain gauge has a gauge factor of two. Its nominal resistance is 120 ohms. If it undergoes a strain of 10-5, the value of change of resistance in response to the strain is 0.0012 Ohm. 0.0024 Ohm. 240 Ohm. 120 Ohm. 0.0012 Ohm. 0.0024 Ohm. 240 Ohm. 120 Ohm. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation ______ instruments are most sensitive. Permanent magnet moving coil Moving iron Hot wire Dynamometer Permanent magnet moving coil Moving iron Hot wire Dynamometer ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation In an Anderson bridge, the unknown inductance is measured in terms of Known inductance and resistance Known capacitance and resistance Known resistance Known inductance Known inductance and resistance Known capacitance and resistance Known resistance Known inductance ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A dynamometer wattmeter can be used for DC only Any of the listed here AC only Both DC and AC DC only Any of the listed here AC only Both DC and AC ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A sampling wattmeter is used to measure the average power of a load. The peak to peak voltage of a square wave is 10 V and the current is triangular wave of 5 Amp P-P as shown in the figure. The period is 20 ms. The reading in W will be 25 W. 50 W. 100 W. 0 W. 25 W. 50 W. 100 W. 0 W. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS