Measurement and Instrumentation Unit of deflection sensitivity of a CRO is meter / volt. mm / V. mm per mV. V / mm. meter / volt. mm / V. mm per mV. V / mm. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A set of independent current measurements taken by four observers was recorded as : 117.02 mA, 117.11 mA, 117.08 mA and 117.03 mA. What is the range of error ? ± 0.045 ± 0.054 ± 0.065 ± 0.056 ± 0.045 ± 0.054 ± 0.065 ± 0.056 ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Assertion(A): A low power factor wattmeter has special constructional features to ensure accurate measurment. Reason(R): Extension of wattmeter range in DC circuit can be easily done by using current and potential transformer A is true R is false. A is false R is true. Both A and R is true and R is correct explanation of A C. Both A and R is true and R is not correct explanation of A. A is true R is false. A is false R is true. Both A and R is true and R is correct explanation of A C. Both A and R is true and R is not correct explanation of A. ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation A resistance is measured by the voltmeter-ammeter method employing dc excitation and a voltmeter of very high resistance connected directly across the unknown resistance. If the voltmeter and ammeter reading are subject to maximum possible errors of ± 2.4 % and ± 1.0 % respectively, then the magnitude of the maximum possible percentage error in the value of resistance deduced from the measurement is nearly ± 3.4% ± 1.4% ± 2.4% ± 1% ± 3.4% ± 1.4% ± 2.4% ± 1% ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation What is the approximate input impedance of a CRO? 1 MΩ 100 MΩ 10 MΩ 0 1 MΩ 100 MΩ 10 MΩ 0 ANSWER DOWNLOAD EXAMIANS APP
Measurement and Instrumentation Potentiometer method of DC voltage measurement is more accurate than direct measurement using a voltmeter because It loads the circuit to maximum extent. It does not load the circuit at all. It loads the circuit moderately. It uses centre zero galvanometer instead of voltmeter. It loads the circuit to maximum extent. It does not load the circuit at all. It loads the circuit moderately. It uses centre zero galvanometer instead of voltmeter. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS