Machine Design In unilateral system of tolerance, the tolerance is allowed on Both sides of the actual size Both sides of the nominal size One side of the actual size One side of the nominal size Both sides of the actual size Both sides of the nominal size One side of the actual size One side of the nominal size ANSWER DOWNLOAD EXAMIANS APP
Machine Design In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by Decreasing the cross-section area of bar Would depend upon other factors Increasing the cross-section area of bar Remain unaffected with cross-section area Decreasing the cross-section area of bar Would depend upon other factors Increasing the cross-section area of bar Remain unaffected with cross-section area ANSWER DOWNLOAD EXAMIANS APP
Machine Design The property of a material which enables it to resist fracture due to high impact loads is known as Endurance Strength Toughness Elasticity Endurance Strength Toughness Elasticity ANSWER DOWNLOAD EXAMIANS APP
Machine Design Two shafts ‘A’ and ‘B’ under pure torsion are of identical length and identical weight and are made of the same material. The shaft ‘A’ is solid and the shaft ‘B’ is hollow. We can say that Shaft A is better than shaft B Shaft B is better than shaft A Both the shafts are equally good None of these Shaft A is better than shaft B Shaft B is better than shaft A Both the shafts are equally good None of these ANSWER DOWNLOAD EXAMIANS APP
Machine Design Transverse fillet welded joints are designed for Tensile strength Compressive strength Bending strength Shear strength Tensile strength Compressive strength Bending strength Shear strength ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a steam engine, the piston rod is usually connected to the cross-head by means of a Cotter joint Oldham coupling Knuckle joint Universal joint Cotter joint Oldham coupling Knuckle joint Universal joint ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS