Machine Design A double fillet welded joint with parallel fillet weld of length 'l' and leg 's' is subjected to a tensile force 'P'. Assuming uniform stress distribution, the shear stress in the weld is given by P/√2.s.l 2P/s.l P/2.s.l √2P/s.l P/√2.s.l 2P/s.l P/2.s.l √2P/s.l ANSWER DOWNLOAD EXAMIANS APP
Machine Design If the centre distance of the mating gears having involute teeth is varied within limits, the velocity ratio Decreases None of these Increases Remains unchanged Decreases None of these Increases Remains unchanged ANSWER DOWNLOAD EXAMIANS APP
Machine Design While designing a screw in a screw jack against buckling failure, the end conditions for the screw are taken as One end fixed and the other end free One end fixed and the other end hinged Both the ends hinged Both the ends fixed One end fixed and the other end free One end fixed and the other end hinged Both the ends hinged Both the ends fixed ANSWER DOWNLOAD EXAMIANS APP
Machine Design In the case of an elastic bar fixed at upper end and loaded by a falling weight at lower end, the shock load produced can be decreased by Decreasing the cross-section area of bar Would depend upon other factors Increasing the cross-section area of bar Remain unaffected with cross-section area Decreasing the cross-section area of bar Would depend upon other factors Increasing the cross-section area of bar Remain unaffected with cross-section area ANSWER DOWNLOAD EXAMIANS APP
Machine Design A steel containing _________ 0.8% carbon is known as hypo-eutectoid steel. Equal to Greater than None of these Less than Equal to Greater than None of these Less than ANSWER DOWNLOAD EXAMIANS APP
Machine Design The velocity factor for ordinary cut gears operating at velocities up to 12.5 m/s is equal to 6/(6 + v) 0.75/(0.75 + √v) 3/(3 + v) 4.5/(4.5 + v) 6/(6 + v) 0.75/(0.75 + √v) 3/(3 + v) 4.5/(4.5 + v) ANSWER DOWNLOAD EXAMIANS APP