Machine Design For standard coarse threads of nut, the threads will be as strong in failure by shear as the bolt in tension, if the height of nut (h) is approximately 0.8 times 0.7 times 0.6 times 0.4 times 0.8 times 0.7 times 0.6 times 0.4 times ANSWER DOWNLOAD EXAMIANS APP
Machine Design A woodruff key is All of these Fitted in pairs at right angles A tapered key with head at one end Capable of tilting in a recess milled out in the shaft All of these Fitted in pairs at right angles A tapered key with head at one end Capable of tilting in a recess milled out in the shaft ANSWER DOWNLOAD EXAMIANS APP
Machine Design According to Indian standard specifications, a Grey cast iron designated by 'FG 200' means that the Minimum tensile strength is 200 N/mm² Carbon content is 2% Maximum compressive strength is 200 N/mm² Maximum shear strength is 200 N/mm² Minimum tensile strength is 200 N/mm² Carbon content is 2% Maximum compressive strength is 200 N/mm² Maximum shear strength is 200 N/mm² ANSWER DOWNLOAD EXAMIANS APP
Machine Design The included angle for the V-belt is usually 30°-40° 40°-60° 60°-80° 10°-20° 30°-40° 40°-60° 60°-80° 10°-20° ANSWER DOWNLOAD EXAMIANS APP
Machine Design If P1 and P2 are the tight and slack side tensions in the belt, then the initial tension Pi (neglecting centrifugal tension) will be equal to (Where, Pc is centrifugal tension) [⅟₂ × (P1 + P2)] + Pc P1 + P2 P1 - P2 ⅟₂ × (P1 + P2) [⅟₂ × (P1 + P2)] + Pc P1 + P2 P1 - P2 ⅟₂ × (P1 + P2) ANSWER DOWNLOAD EXAMIANS APP
Machine Design Stress concentration factor is defined as the ratio of Maximum stress to the nominal stress Nominal stress to the maximum stress Maximum stress to the endurance limit Nominal stress to the endurance limit Maximum stress to the nominal stress Nominal stress to the maximum stress Maximum stress to the endurance limit Nominal stress to the endurance limit ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS