Machine Design In thrust bearings, the load acts Along the axis of rotation Parallel to the axis of rotation Perpendicular to the axis of rotation In any direction Along the axis of rotation Parallel to the axis of rotation Perpendicular to the axis of rotation In any direction ANSWER DOWNLOAD EXAMIANS APP
Machine Design In order to determine the stresses in a thin cylinder due to an internal pressure, it is assumed that The effect of curvature of the cylinder wall is neglected All of these The effect of the restraining action of the heads at the end of the pressure vessel is neglected The tensile stresses are uniformly distributed over the section of the walls The effect of curvature of the cylinder wall is neglected All of these The effect of the restraining action of the heads at the end of the pressure vessel is neglected The tensile stresses are uniformly distributed over the section of the walls ANSWER DOWNLOAD EXAMIANS APP
Machine Design The power transmitted by the belt drive can be increased by Increasing wrap angle by using idler pulley Increasing the initial tension in the belt All of these Dressing the belt to increase the coefficient of friction Increasing wrap angle by using idler pulley Increasing the initial tension in the belt All of these Dressing the belt to increase the coefficient of friction ANSWER DOWNLOAD EXAMIANS APP
Machine Design A V-belt designated as B 4430 LP has 4430 mm as diameter of small pulley 4430 mm as nominal pitch length 4430 mm as centre distance between pulleys 4430 mm as diameter of large pulley 4430 mm as diameter of small pulley 4430 mm as nominal pitch length 4430 mm as centre distance between pulleys 4430 mm as diameter of large pulley ANSWER DOWNLOAD EXAMIANS APP
Machine Design The application of second type levers is found in Lever of a loaded safety valve A pair of tongs Hand wheel of a punching press Handle of a hand pump Lever of a loaded safety valve A pair of tongs Hand wheel of a punching press Handle of a hand pump ANSWER DOWNLOAD EXAMIANS APP
Machine Design The stress in the threaded part of the bolt will be __________ as compared to the shank. Same Lower Higher None of these Same Lower Higher None of these ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS