Workshop Technology
In permanent mould casting method

Molten metal is poured and allowed to solidify while the mould is revolving
Molten metal is poured in a metallic mould, retained in the mould long enough for the outer skin to solidify and finally mould is turned over to remove molten metal still in molten condition
None of these
Molten metal is forced into mould under high pressure

ANSWER DOWNLOAD EXAMIANS APP

Workshop Technology
Extrusion

Is used to improve fatigue resistance of the metal by setting up compressive stresses in its surface
Consists of pressing the metal inside a chamber to force it out by high pressure through an orifice which is shaped to provide the desired form of the finished part
Is used for reducing the diameter of round bars and tubes by rotating dies which open and close rapidly on the work
Is extensively used for making bolts and nuts

ANSWER DOWNLOAD EXAMIANS APP

Workshop Technology
Swab is used for

Moistening the sand around the edge before removing pattern
Smoothing and cleaning out depressions in the mould
Cleaning the moulding sand
Reinforcement of sand in the top part of the moulding box

ANSWER DOWNLOAD EXAMIANS APP