Manufacturing And Production Technology In drilling Bakelite and fibrous plastics, the point angle of a drill is 135° 150° 90° 118° 135° 150° 90° 118° ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology When 3-2-1 principle is used to support and locate a three dimensional work-piece during machining, the number of degrees of freedom that are restricted is 8 9 7 10 8 9 7 10 ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The angle on which the strength of the tool depends is Clearance angle Lip angle Cutting angle Rake angle Clearance angle Lip angle Cutting angle Rake angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A 15 mm drilling machine means that it can drill a hole In 15 mm thick plates None of these Of maximum diameter 15 mm In 15 mm thick plates None of these Of maximum diameter 15 mm ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A single point thread cutting tool should ideally have Positive rake angle Point angle Zero rake angle Negative rake angle Positive rake angle Point angle Zero rake angle Negative rake angle ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology A diamond locating pin is used in jigs and fixtures because It helps in assembly with tolerance on centre distance It has a long life It occupies very little space Diamond is very hard and wear resistant It helps in assembly with tolerance on centre distance It has a long life It occupies very little space Diamond is very hard and wear resistant ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS