Manufacturing And Production Technology In lapping operation, the amount of metal removed is 0.5 to 1 mm 0.05 to 0.1 mm 0.01 to 0.1 mm 0.005 to 0.01 mm 0.5 to 1 mm 0.05 to 0.1 mm 0.01 to 0.1 mm 0.005 to 0.01 mm ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology Green sand mould indicates that Mould contains moisture Mould has been totally dried Mould is green in colour Polymeric mould has been cured Mould contains moisture Mould has been totally dried Mould is green in colour Polymeric mould has been cured ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The chamfering is an operation of Beveling the extreme end of a workpiece Enlarging the end of a hole cylindrically Embossing a diamond shaped pattern on the surface of a workpiece Reducing the diameter of a workpiece over a very narrow surface Beveling the extreme end of a workpiece Enlarging the end of a hole cylindrically Embossing a diamond shaped pattern on the surface of a workpiece Reducing the diameter of a workpiece over a very narrow surface ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology In a single point turning operation with a cemented carbide and steel combination having a Taylor exponent of 0.25, if the cutting speed is halved, then tool life will become Sixteen times Two times Eight times Half Sixteen times Two times Eight times Half ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The factor which affects the tool life is All of these Feed rate Cutting speed Tool geometry All of these Feed rate Cutting speed Tool geometry ANSWER DOWNLOAD EXAMIANS APP
Manufacturing And Production Technology The carbide tools operating at very low cutting speeds (below 30 m/min) Spoils the work piece Have no effect on tool life Reduces tool life Increases tool life Spoils the work piece Have no effect on tool life Reduces tool life Increases tool life ANSWER DOWNLOAD EXAMIANS APP