Workshop Technology In die casting, machining allowance is Very large Not provided Small Large Very large Not provided Small Large ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology When a hole or cavity to be cored is not in line with the parting surface, then a ________ is used. Drop core Horizontal core Vertical core Balanced core Drop core Horizontal core Vertical core Balanced core ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For obtaining a cup of diameter 25 mm and height 15 mm by drawing, the size of the round blank should be approximately 46 mm 44 mm 42 mm 48 mm 46 mm 44 mm 42 mm 48 mm ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology Green sand is a mixture of 50% sand and 50% clay 30% sand and 70% clay 70% sand and 30% clay 90% sand and 10% clay 50% sand and 50% clay 30% sand and 70% clay 70% sand and 30% clay 90% sand and 10% clay ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology V-block is used to Check the trueness of flat surfaces None of these Check the surface roughness Locate centres of round rods Check the trueness of flat surfaces None of these Check the surface roughness Locate centres of round rods ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In a compound die Only one operation is performed at each stroke of the ram Two or more operations are performed simultaneously at the single stroke of the ram Both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram Two or more cutting operations are performed at one station of the press in every stroke of the ram Only one operation is performed at each stroke of the ram Two or more operations are performed simultaneously at the single stroke of the ram Both cutting and non-cutting operations are performed at one station of the press in every stroke of the ram Two or more cutting operations are performed at one station of the press in every stroke of the ram ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS