Workshop Technology In a ___, the molten metal is poured and allowed to solidify while the mould is revolving. Slush casting method Permanent mould casting method Centrifugal casting method Die casting method Slush casting method Permanent mould casting method Centrifugal casting method Die casting method ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For welding plates of thickness more than 12.5 mm, its edges Should have a double-V or U-groove on both sides Do not require bevelling Should be bevelled to a single-V or U-groove Should have a double-V or U-groove on one side Should have a double-V or U-groove on both sides Do not require bevelling Should be bevelled to a single-V or U-groove Should have a double-V or U-groove on one side ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology In backhand welding, the angle between the welding rod and the work is ___ as compared to forehand welding. None of the listed here Less Same More None of the listed here Less Same More ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The chisel used for cutting key ways is Diamond pointed chisel Round nose chisel Cape chisel Flat chisel Diamond pointed chisel Round nose chisel Cape chisel Flat chisel ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology The fullers are used For finishing flat surfaces To finish the punched hole For punching a hole For necking down a piece of work For finishing flat surfaces To finish the punched hole For punching a hole For necking down a piece of work ANSWER DOWNLOAD EXAMIANS APP
Workshop Technology For gas welding, the pressure desired at the welding torch for acetylene is 7 to 103 kN/m² 280 to 560 kN/m² 70 to 280 kN/m² 560 to 840 kN/m² 7 to 103 kN/m² 280 to 560 kN/m² 70 to 280 kN/m² 560 to 840 kN/m² ANSWER DOWNLOAD EXAMIANS APP