Machine Design In a marine flange coupling, the thickness of flange is taken as d/2 d/4 3d/4 d/3 d/2 d/4 3d/4 d/3 ANSWER DOWNLOAD EXAMIANS APP
Machine Design Two shafts of the same length and material are joined in series. If the ratio of their diameters is 2, then the ratio of their angles of twist will be 4 2 16 8 4 2 16 8 ANSWER DOWNLOAD EXAMIANS APP
Machine Design In V-belt drive, belt touches Could touch anywhere Both at bottom and sides At sides only At bottom Could touch anywhere Both at bottom and sides At sides only At bottom ANSWER DOWNLOAD EXAMIANS APP
Machine Design The groove angle of pulleys for V-belt is 420 to 450 More than 400 340 to 360 300 to 320 420 to 450 More than 400 340 to 360 300 to 320 ANSWER DOWNLOAD EXAMIANS APP
Machine Design Gears are casted by Permanent mould casting Centrifugal casting Slush casting Sand mould casting Permanent mould casting Centrifugal casting Slush casting Sand mould casting ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft coupling should Be easy to connect or disconnect Transmit full power of the shaft All of these Hold the shafts in perfect alignment Be easy to connect or disconnect Transmit full power of the shaft All of these Hold the shafts in perfect alignment ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS