Electrical Machines In a DC Shunt Motor if the load current increases keeping the terminal voltage constant, then flux will remain constant. decrease. increase. any of the above. remain constant. decrease. increase. any of the above. ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines Which type motors are preferred for lathes? DC shunt motors. Either A or B. Squirrel Cage induction motor. Synchronous motor. DC shunt motors. Either A or B. Squirrel Cage induction motor. Synchronous motor. ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines If the full load speed of 3-phase, 50Hz induction motor is 950 rpm, what is its half load speed nearly equals to? 950 rpm 940 rpm 1000 rpm 975 rpm 950 rpm 940 rpm 1000 rpm 975 rpm ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines What will be the e.m.f. generated by a 4 pole lap connected DC Generator rotating at 1500 r.p.m.? Its flux per pole is 0.4 mWb and total no of armature conductors is 1000. 20 volts. 30 volts. 40 volts. 10 volts. 20 volts. 30 volts. 40 volts. 10 volts. ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines Which type of bearing is provided in small induction motors to support the rotor shaft? Cast iron bearings. None of these Ball bearings. Bush bearings. Cast iron bearings. None of these Ball bearings. Bush bearings. ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines Autotransformer makes effective saving on copper and copper losses, when its transformation ratio is equal to approx to one. greater than one. less than one. very low approx to one. greater than one. less than one. very low ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS