Electrical Machines In a DC Motor 3 point starter is used to provide overload protection. limit the starting current to a safer value. provide protection against Low-Voltage. all of above. provide overload protection. limit the starting current to a safer value. provide protection against Low-Voltage. all of above. ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines Reversing the direction of rotation of split phase motors is done by interchanging the capacitor from starting winding to main winding or vice versa. reversing the terminals of main winding. All of these reversing the terminals of starting winding. interchanging the capacitor from starting winding to main winding or vice versa. reversing the terminals of main winding. All of these reversing the terminals of starting winding. ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines In dc machines, the field system has to be provided on stator unlike synchronous machines Where in it could be on any member, because it gives more uniform air-gap flux distribution it reduces field structure iron losses commutator action is not possible otherwise dc machines are comparatively low rating machines. it gives more uniform air-gap flux distribution it reduces field structure iron losses commutator action is not possible otherwise dc machines are comparatively low rating machines. ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines The magnetic field which initially induces emf in the armature in a self excited DC generator is because of permanent magnets. residual magnetism. armature reaction. None of these permanent magnets. residual magnetism. armature reaction. None of these ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines A 5 KVA transformer has a turns ratio of N1/N2 = 10. The impedance of primary winding is 3+j5 ohms while that of secondary winding is 0.5+j0.8 ohms. The impedance of transformer when referred to primary will be 3.5+j5.8 ohms 3.05+j5.08 ohms 53+j85 ohms 8+j13 ohms 3.5+j5.8 ohms 3.05+j5.08 ohms 53+j85 ohms 8+j13 ohms ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines Silicon content in steel lamination is kept within 5% as it increases hysteresis loss. All of these makes the material brittle. Increases cost. increases hysteresis loss. All of these makes the material brittle. Increases cost. ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS