Electrical Machines Cross magnetization effects which of the following? commutation reduction in main field flux both 2 and 3 reduces the terminal voltage commutation reduction in main field flux both 2 and 3 reduces the terminal voltage ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines In a DC Shunt Motor if the load current increases keeping the terminal voltage constant, then flux will increase. remain constant. decrease. any of the above. increase. remain constant. decrease. any of the above. ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines The introduction of interpoles in between the main poles improves the performance of a dc machine, because a counter-emf is induced in the coil undergoing commutation the interpoles produce additional flux to augment the developed torque the inequality of air-gap flux on the top and bottom halves of the armature is removed the flux waveform is improved with reduction in harmonics a counter-emf is induced in the coil undergoing commutation the interpoles produce additional flux to augment the developed torque the inequality of air-gap flux on the top and bottom halves of the armature is removed the flux waveform is improved with reduction in harmonics ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines The heat generated in the transformer is dissipated mainly by radiation. conduction. All of these convection. radiation. conduction. All of these convection. ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines Two synchronous generators operating in parallel 200 MW and 400 MW respectively. The drooping characteristics of their governors are identical as 4% from no load to full load. Consider the governors operating at 50Hz on no load. How will the machine share, if the load is 600 MW? 230.7 MW and 369.23 MW respectively 200 MW and 400MW respectively generator 1 gets over load generator 2 gets over load 230.7 MW and 369.23 MW respectively 200 MW and 400MW respectively generator 1 gets over load generator 2 gets over load ANSWER DOWNLOAD EXAMIANS APP
Electrical Machines The brushes of a DC machine should be placed on the armature midway between poles. commutator in the inter polar axis. armature in the polar axis. commutator in the polar axis. armature midway between poles. commutator in the inter polar axis. armature in the polar axis. commutator in the polar axis. ANSWER DOWNLOAD EXAMIANS APP