Analog Electronics If the zener diode in a zener regulator is connected with the wrong polarity, the load voltage will be closest to 0.7 V. 10 V. 14 V. 18 V. 0.7 V. 10 V. 14 V. 18 V. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics The feedback factor of a Wien bridge oscillator using Op-Amp is 1/4 1 1/2 1/3 1/4 1 1/2 1/3 ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics Why is silicon preferred than germanium ? Current sensitivity of silicon with temperature is less Silicon has higher tolerance to temperature All the above Leakage current due to minority charge carrier is less in silicon Current sensitivity of silicon with temperature is less Silicon has higher tolerance to temperature All the above Leakage current due to minority charge carrier is less in silicon ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics Field effect transistor (FET) operates on majority carriers only. positive charged ions only. on both majority and minority carriers. minority carries only . majority carriers only. positive charged ions only. on both majority and minority carriers. minority carries only . ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics A common - mode signal is applied to the non - inverting input. the inverting input. both inputs. the top of the tail resistor. the non - inverting input. the inverting input. both inputs. the top of the tail resistor. ANSWER DOWNLOAD EXAMIANS APP
Analog Electronics An amplifier using an opamp with slew rate SR=1v/µsec has a gain of 40db.if this amplifier has to faithfully amplify sinusoidal signals from dc to 20 KHz without introducing any slew-rate induced distortion, then the input signal level must not exceed 395mV 79.5 mV 39.5mV 795mV 395mV 79.5 mV 39.5mV 795mV ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS