Machine Design If an application calls for stresses on screw threads in one direction only, then the following type of thread would be best suited Buttress Square BSW Acme Buttress Square BSW Acme ANSWER DOWNLOAD EXAMIANS APP
Machine Design A shaft is subjected to a maximum bending stress of 80 N/mm² and maximum shearing stress equal to 30 N/mm² at a particular section. If the yield point in tension of the material is 280 N/mm² and the maximum shear stress theory of failure is used, then the factor of safety obtained will be 2.5 3.5 3 2.8 2.5 3.5 3 2.8 ANSWER DOWNLOAD EXAMIANS APP
Machine Design Yield point in fatigue loading as compared to static loading is Same Depends on other factors Higher Lower Same Depends on other factors Higher Lower ANSWER DOWNLOAD EXAMIANS APP
Machine Design In a hydrodynamic lubricated bearing There is a thin film of lubricant between the journal and the bearing There is a thick film of lubricant between the journal and the bearing The lubricant is forced between the journal and the bearing, by external pressure There is no lubricant between the journal and the bearing There is a thin film of lubricant between the journal and the bearing There is a thick film of lubricant between the journal and the bearing The lubricant is forced between the journal and the bearing, by external pressure There is no lubricant between the journal and the bearing ANSWER DOWNLOAD EXAMIANS APP
Machine Design The ratio of driving tensions for flat belts, neglecting centrifugal tension, is (where T₁, and T₂ = Tensions on the tight and slack sides of belt respectively, μ = Coefficient of friction, between the belt and pulley, and θ = Angle of contact) T₁/T₂ =eμθ T₁/T₂ = μθ log (T₁/T₂) = μθ T₁/T₂ = log μθ T₁/T₂ =eμθ T₁/T₂ = μθ log (T₁/T₂) = μθ T₁/T₂ = log μθ ANSWER DOWNLOAD EXAMIANS APP
Machine Design If a material fails below its yield point, failure would be due to Sudden loading Straining Fatigue Creep Sudden loading Straining Fatigue Creep ANSWER DOWNLOAD EXAMIANS APP
EXAMIANS